Recommended Replica lip, diffuser and side skirts?
 

Anyone have particular sellers for front lip, side skirts, and rear diffuser, hopefully affordable and PU?

I almost bought from benz-vs-bmw but reading a few reviews here, and on eBay, looks like it's not worth the $20 savings compared to other sellers.

Search the forums but only a small handful of names!

Thanks. :thanks:

The bayson R lip kit on eBay is supposed to be pretty decent.

I also recommend BaysonR from ebay. They ship pretty quickly and products fit very well for the price. Haven't had any problems with skirts/lip/diffuser other than the cheap plastic clips they came with.

I like the ABS Style, but I want PolyUrethane.

What about HTAutos ?

http://www.ebay.com/itm/Subaru-BRZ-B...item485677a11b

they got their supplies from JCSportline over at China. quality is just meh...but price is decent.

+1 for BaysonR

Bayson R's front lip is good, and is PU

Yup BaysonR, cheap but great fitment

were located in california as well and have alot of great lips, diffusers and sideskirts!

check out the website at www.extremedimensions.com and pm me if you have any questions

Gonna beat this thread to death, Bayson R.

Had to re drill a couple of holes to fix a forced flex in my front lip but look and fitment are better then most ebay kits. I have also seen htauto good fitment and quality but they cost a little more.

Ah,

I found the PU Style + STi lip that I wanted!!!

http://www.baysonr.com/12_14_Subaru_...-brz13-sti.htm

I couldn't find it on the eBay store. Thanks everyone, time to contact Bayson R myself.


Any tips for cheap side skirts? Most are the same price as a rear diffuser + a front lip.

Do I have to drill? Rather use 3M.

anyone have direct or previously contacted jcsportline?
ive been trying to get a hold of them
thanks

I chose to drill and used new hardware because the hardware provided rusts all to shit over time and doesnt inspire confidence as far as holding up is concerned. I prefer to use small washers added to self tapping screws with a bit bigger head. I also drilled the holes prior to aid in installation. The ones I had to redrill were required in my opinion because the holes did not align with the holes in the bumper/plastic underneath so it required a widening of the hole on the lip so that it would not cause the lip to flex, a noticeable flex IMO.

Just received their cs style side skirts, looks like these will call for redrilling also and better hardware, but they look good, a little wet sanding to get rid of the mold lines and some black plastidip for that factory look and she will be just fine
;)