Omni 4 Bar Settings
 

I noticed this wasn't posted anywhere and thought it would be nice to keep this info here.

Manifold Pressure Sensor Scaling -
Multiplier - 12.087
Offset - 0.168

Manifold Pressure Sensor Limits - (CEL still comes on for me)
High Input CEL Above - 5.00v
Low Input CEL Below - 0.00v

Since I was still getting CEL's for P0103 and P0068 I just turned them off.

If anyone finds a way to keep those DTC's on in case there is ever an error that we need to know about, please let me know so I can change this. Thanks!

*EDIT*Just ran into some more MAP sensor settings here: http://www.ft86club.com/forums/showthread.php?t=64790

these scalings for different maf sensor would probably be a usefull addition to the maf scaling thread will add

im pretty sure the oft 300 vortex tunes disable those cels as well, something to do with rate of change outside limits