17x9 +35 720Form GTF1 installed!
 

17x9 +35 720Form GTF1 (16.8lbs) with 255/40/17 Dunlop Direzza Z11 square setup.
RCE Yellow Springs, Bilsten Sport Shocks, Eibach Sway Bars, Raceseng Camber Plates, SPC Rear LCAs.

Photos:

https://fbcdn-sphotos-b-a.akamaihd.n...50522415_n.jpg
https://scontent-b-sea.xx.fbcdn.net/...05063429_n.jpg
https://scontent-b-sea.xx.fbcdn.net/...32845291_n.jpg
https://fbcdn-sphotos-c-a.akamaihd.n...27915670_n.jpg
https://scontent-a-sea.xx.fbcdn.net/...25542955_n.jpg
https://scontent-a-sea.xx.fbcdn.net/...90128086_n.jpg
https://fbcdn-sphotos-h-a.akamaihd.n...92194416_n.jpg

Awesome looking 17" wheel, a D the 255's looking meaty. Thanks for posting!

No problem and thanks :D

hot damn, finally! I wish these came in different colors, because powdercoating makes these not nearly so cheap. glad to see these on an actual car now, thanks!

how is your tire-to-perch clearance up front?

oh, and is it just me or is that last pic showing a backwards tire?

Clearance is 5+mm but I have my plates set at -2.7 degrees of camber.

Yes tire was backwards, didn't drive on them yet just test fitted when I got them so I wasn't worried about that haha.

Hmm still waiting to see if these will clear the Essex Sprint kit. If they do it's between these and Gunmetal RPF1s since my SBC RPF1s got stolen. I'd definitely get the 720Form wheels powder coated though, would end up being just about the same cost as the RPF1s.

I don't suppose you could print out this template and check?

http://www.essexparts.com/media/down...eltemplate.pdf

I will try and get that done this weekend for you.

Thank you, I know I'm not the only one wondering this info.

I have the template ready, will do my best tonight to see.

You have any poke pics?

Nice!

Where did you get them? I plan to get the GTF3s.

They don't poke on my car they are damn near flush.

These are actually pretty light. I'm impressed.

1010Tires