I am installing a new skullworks sandwitch plate for my RObispec Oil Cooler but I don't have any instructions on what hose goes to which nipple. Any of you smart guys/gals out there can help me out?

From looking at it I think the Oil goes up and through the bottom nipple to to the bottom of the oil cooler. Then the oil travels up through the oil cooler and out the hose to the top nipple of the sandwitch plate. Then the Oil travels up through the Oil Filter and then down to the engine.

This is the plate:

http://i240.photobucket.com/albums/f...pse6f5966a.jpg

Upper port on the sandwich plate connects to the upper port on the radiator, and lower to lower, respectively. The 90 degree elbow goes on the lower port.

@Sportsguy83 to the rescue

What he ^^^^^ said...

Disregard the red circle look at the sandwich plate.

Oil goes into the cooler at the bottom and comes into the plate up top.

http://www.ft86club.com/forums/attac...8&d=1397004998

Sent from my SM-N900A using Tapatalk

Damn.. I saw this picture earlier and didn't realize it was your car.


Sent from my IBrick

I saw it earlier too and didn't realize it either.... for real... LMAOOO

Sent from my SM-N900A using Tapatalk