Nameless 2.5" Axbleback + OP/DP with headers?
 

I just ordered a Nameless 2.5" axleback with their OP/DP replacement. I want something that is fairly loud and aggressive with as little drone as possible. Do you guys think this set up with the new Nameless EL Headers will drone and be too loud for DD? Curious to hear what you guys think, i know its tough considering as far as i know nobody is even running the Nameless EL headers as of yet.

There are a few of the testers running that setup..... As far as I could tell is that it shouldn't drone if you got the resonator in the dp but it will be loud.

Not sure how loud though as preferences vary.

It's what I plan on doing.

That setup with uel headers didn't drone for me. It was loud and raspy though at wot.

I have the nameless 2.5 with 5" mufflers.. It's a great sound with everything else stock.. I wouldn't want it any louder for my tastes..
It will surely be louder with your plans.. I don't think you can avoid the drone at certain rpms and load.. It's not bad as it sits stock.. But once you open it up some more.. It will get loud for sure.. How loud or bad it will be is subjective.. But it should be a good bit louder for sure..

I'm thinking about adding a resonator to the stock mid pipe to keep the rasp down.

Should be fairly cheap

I have the 2.5 system with 5" offset mufflers and a resonated op/fp combo. I'm hoping that will keep the header somewhat quiet as well. My order is in the 2nd batch though. I hope to be able to dyno the car as it sits, then with the header installed, and then tuned. I know a lot of people would like to see that.