SOLD: Invidia Q300 Titanium Tips (Round Rock/Austin, TX) $450
 

Hey guys, I'm selling my Q300 as I swapped to an N1. The Q300 is very tame, very quiet inside the cabin and perfect for a DD or quietening down a loud catless header. It was used for about 500 miles, then removed. The right tip has a couple small scratches which I believe came from the lift I installed it on, but they can only really be seen very close up and they are more on the bottom right side. See picture below.

I'm asking $450 local pick up only. It would cost a ton to ship this. Condition other than the small scratches on that right tip is excellent. I've even got the hard part done for you with tightening the clamp to the muffler which I kept on and it does not leak at all. This will also come with a brand new mid pipe still in wrapping from my N1 as I left the same Q300 midpipe on my car when I installed the N1. They're the exact same pipe.

http://i1133.photobucket.com/albums/...ps24c8e96b.jpg

http://i1133.photobucket.com/albums/...ps55b40f7d.jpg

This item is sold!

Matt, what fp are you running with the JDL and N1? I was going to go with a 2.5 Perrin resonated and JDL UEL, but ur saying it might be too quiet? Everyone has a different opinion but you've had the Nameless exhaust before and said it was waaaay too loud and I trust your judgement


Sent from my iPhone using Tapatalk

Invidia Catted Front Pipe. 0 rasp, a little bit of drone, but REAL deep and loud. Exactly where I love it. 3" exhausts have a bunch of rasp when it's a full 3" headerback from the pipe sizing. The Invidia resonated front pipe might also work well.

The Perrin resonated 2.5" is a bit louder than the Q300, but not by very much. Very tame DD friendly systems with 0 drone.

FS: Invidia Q300 Titanium Tips (Round Rock/Austin, TX) $450
 

A friend has the JDL w/op and N1, not sure about the fp though. But I personally think it's LOUD. Sounds amazing but just a tad too loud. But I'm afraid the Perrin res/Invidia q300 will be too quiet. You think a Perrin unres might work out? Thx for your opinion. It helps when you've already owned three of the most popular exhaust we have available. Lol


Sent from my iPhone using Tapatalk

Why would a Perrin unres sound raspy but an N1 wouldn't?


Sent from my iPhone using Tapatalk

Just figured out my own ? The N1 has a resonator in midpipe, Perrin obviously doesn't?!?


Sent from my iPhone using Tapatalk

The N1 has a smaller resonator than Perrin's resonates. Do not go unresonated as it will get raspy. Yes, the N1 is loud no doubt. You can control the tone with adding a catted or resonated front pipe, a catted header, and if you want to kill some drone, the Nameless DP/OP is a great choice with the Helmholtz. The Q300 is much louder from behind than when you're in the driver's seat. You'll hear more engine noise. I really do like the Q300 some days. It is a beautiful exhaust.

Back on topic, I still have my Q300 for local pickup!

Bump

What were the Power Gains?

About the same as many other catbacks, but definitely better than stock. The Q300 has very few bends in it.

I may be interested if you end up you would want to ship it.

If you still have the original box, it won't really cost that much to ship. I've shipped two exhausts now, both ending up around 50-60 bucks.

If you'll do $400, I'll come by next weekend and get it. I'm in Houston, so it's a bit of a drive.

Tossed the box. :(