Radium Engineering Catch Cans
 

Radium Engineering just released a new dual catch can kit for the twins.
http://www.radiumauto.com/Catch-Can-...Z-86-P374.aspx

my kit will be here tomorrow. woohoo.

Thanks! I've been holding off from buying one of these(I'm using CUSCO atm) but with easy bolt-on I think I'll order one

Not fair my has not shipped yet. :angry:

Any NA guys running dual? I ordered the PCV version yesterday but like symmetry and will probably order the other can this summer.

Looks like they shipped my order one day early. :w00t:

I really like this kit they've thought it out well IMO. Only thing is where the brace mounts in back section, I'm curious if that will interfere with the many good damper kits? For those that mount these up please come back to post some thoughts. :)

Well observed...
Just by eyeballing it, I would say no...
Looks to me like the damper will hit the bracket.
Depends on how high that bracket actually is.

Damn, I was just about to place an order...
If someone buys this kit, would it be possible to measure how high the bracket is?
Might have to buy the universal dual can setup and mount it on the strut as i originally planned.

http://i1275.photobucket.com/albums/...pse291df50.jpg

EDIT: The potential problem is also discussed here.
http://www.ft86club.com/forums/showt...t=21079&page=9
Looks like we will get feedback if it fits or not in that thread.

looks like my kit was just delivered. I'm going to try to at least get one of the two installed tonight. If not though, I'll definitely have them both installed before the weekend is over.

I'm NA and I ordered the dual kit. With the track events I do might as well get both cans now.

Nice @xjohnx looking forward to install pics and notes, highly considering these as these guys make top notch stuff. :clap:

same although I need to verify they will work with my hood struts...

i think @civicdrivr has the grimmspeed hood struts, if so we can likely snag one off his car and test fit it with my catch cans.