Shifter TSB 03-71-13 v. Perrin Rear Shifter Bushing
 

I had the Perrin Shifter Bushing for Rear Shift Rod (PSP-INR-006) installed shortly after I got my BRZ.

Does anyone know if the above shifter TSB replaces the Perrin bushing?

Got the text of the TSB? That would help.

NUMBER: 03-71-13
DATE: 07/01/13

APPLICABILITY:
2013MY BRZ

SUBJECT:
6MT Shifter Rattle and Improvement to
Reverse Pull Collar Operation

INTRODUCTION

This Bulletin announces availability of a revised 6MT shifter lever and an enhancement to the reverse pull collar assembly designed to improve the operation of the reverse selection mechanism. In addition, this new assembly will eliminate a rattle sound from the shifter which may occur primarily in 3rd gear between 3500 and 6000 rpm. While the rattle condition is most noticeable in the listed gear and rpm range, it may in rare cases be noticeable under other conditions.

COUNTERMEASURE IN PRODUCTION

The new shift lever was incorporated into production in December, 2012 starting with VIN: D2605967.






PART INFORMATION






SERVICE PROCEDURE / INFORMATION

Once the customer's concern has been confirmed to be associated with the shift lever, replace the lever assembly following the service procedure outlined in the applicable Service Manual.

WARRANTY / CLAIM INFORMATION






For vehicles within the Basic New Car Limited Warranty period, this repair may be claimed using the information shown.

The best that I can tell from the TSB is that the shift iever is new. The bushing and boot are listed as R&R.

I am a technician for a Subaru dealer in Canada. I have performed this bulletin on my own brz as well as 2 other customer vehicles and can confirm you only replace the shift lever assembly and shifter bushing is left untouched.

Sent from my SGH-I717D