Break duct ( turn signal delete )
 

Im on a mission to find this piece, i tried contacting a few guys who ran RB kits but had no luck so id appreciate it if anybody can chime in both members and vendors

im trying to find this specific piece

http://s21.postimg.org/ewv5xc3af/Scr...5_26_08_PM.png

http://s9.postimg.org/8k64lftcf/5413...01682225_n.jpg

http://s9.postimg.org/hggwpdjyn/AY0_F3344.jpg


Ps: Please dont link the APR break ducts that have room for the turn signals(or any that are similar ), i really don't want them :iono:

Just curious, what's your alternative to turn signal location?

A few options out there, Spyder headlights have integrated turn signals and such :w00t:

I have looked all over for these, I can only assume they are not being mass produced. Only ever seen them on RB cars may be some kind of option with the kit.

These should be released soon

http://www.ml24.net/products/scion_f...ght_vents.html

I may just buy the fog light bezels cut them up and fiberglass my own.

Sick!!!!!



http://www.ml24.net/products/img/ml2..._01_banner.jpg

:barf:Sadly it has a light on it

If you're creative, why not make it on your own? You can make a hole where the fake mesh is and route a pipe to brake.

I really don't want them as break ducts,but i may route them to the engine bay to cool as ill be going with a front mounted turbo.

I was looking at a ready made option as i really dislike the hassle of going custom but if its necessary then i guess ima do it


Sent from my IBrick

I'd like to do a set of these as well

I'm after the exact same thing as well. I've replaced my lights with the ones from a BRZ so have no need for the indicator.

These are in fact a part of the v1 Rocket Bunny kit that only a few people got. Namely the people that got the kit directly from Miura-san rather than a 3rd party like Evasive Motorsports. I talked to StayCrushing about these before and he confirmed they're from TRA_Kyoto. The only person I know of to have these on a non-RB is Kalen Gray with the Jet86, and he said it took him like 6 months of hard searching to get a hold of some.

SMS you have two options IMO.

Either cut out the mesh in your current ones on your bumper and route a pipe directly to the engine bay or get the JDM ones without the fog lights and route the pipes to the engine bay. I've seen a guy removing the fog lights and it looked good, I was planning to do this once I go FI.

Thing is i like the design of having it in the middle , i might get a set of rb v1 fenders soon so ill see if i can get the ducts too, if not i might make my own set with fiberglass or such


Sent from my IBrick

Custom fab one then. I think that would be your best bet.