Perrin Exhaust
 

I've attempted to search but didn't find anything. I'm pretty sure I know the answer but just wanted some feedback from everyone else. Just installed my Perrin 2.5" resonated catback (love it!) but it seems that the left side pokes out a tad bit more than the left....I've heard of a way to adjust the exhaust before for alignment with the bumper but not for the poke.

Anywho it's not a big big deal. Just I like having things perfect when it comes to cars.


Sent from my iPhone using Tapatalk

I've got the exhaust with perfect alignment.

Loosen the vband clamps and start rotating the pipe that connects to the muffler to the resonator pipe.

So just rotate the mid pipe?


Sent from my iPhone using Tapatalk

You can adjust my loosening the 2 v-band clamps and rotating the S-pipe around. You can also adjust the rubber hangers a bit. I was able to get mine very close to even. I think one sticks out about 1/4" more than the other, but unless you're staring down at them from the top, you don't notice it so I left it alone.

Yep, you'll want to loosten the V band on the muffler, and the V band on the other side of the S pipe. When you rotate it, it will change the angle of the muffler to the rear bumper, so it should take care of it. When you tighten the v bands back up, just make sure to either have someone hold the muffler in place or try holding it when you're tightening the V bands.