TF Quad Tipp Axleback exhaust help
 

Hey guys, i'm a little new here and i just have a question, I'm going to install my new exhaust ^as the title says, and i know for a fact the tipps are too big to fit like the J2 exhaust does in the rear bumper. So i was wondering if i cut it wider, until i get the TRD rear bumper would it look hideous? and if i were to cut it what tool should i use?

Thanks in advance

Pictures:

http://i622.photobucket.com/albums/t...7/IMG_1443.jpg

http://i622.photobucket.com/albums/t...7/IMG_1442.jpg

http://i622.photobucket.com/albums/t...7/IMG_1441.jpg

http://i622.photobucket.com/albums/t...7/IMG_1440.jpg

I think it would look hideous without these:
http://www.japanparts.com/db/parts_d...=&SEARCH_page=

I would wait on the install until you get your bumper.

yeah i've seen it before but i don't know if i want to wait another month just to put it on..

Yes, it would look hideous. And you can use a dremel to cut the rear bumper.

I think i'm going to do it because the hideous bumper but the beautiful exhaust just even out ;) and ooh didnt think of that tool.

How much did that exhaust set you back? Thats beautiful!

Not much tbh. 500$ and i love it

check out this guys thread, he has a similar exhaust http://www.ft86club.com/forums/showthread.php?t=51010 ;)

I'm the same person hahah

Where did you find that at? I can't find it online nor a sound clip.

haha yeah i know, i was just messing around. :thumbup:

Look at my video on my other post and i contacted TF personally about it.
http://www.ft86club.com/forums/showthread.php?t=51010