Advan RGD 18 x 8.5" (33) offset squared, no one?
 

Looked in wheel directory only staggered setups, looked online well everywhere for hours lol.

Hoping someone may have done this, don't care what color would just love to see how they look and fit especially in the rear. Since I know front is fine with bit of camber.

If you have these squared and can share a pic would be VERY helpful. Thx :D

similar setup / 18x9.0 +45mm (18x8.5 +39mm)

ADVAN RGD 18" Gold on White BRZ


http://farm9.staticflickr.com/8221/8...8e947f07_b.jpg

http://farm9.staticflickr.com/8498/8...f313ef5d_b.jpg

http://farm9.staticflickr.com/8510/8...7b1714ae_b.jpg

If it looks good in front, it will probably be a little sunk in the rear.

If 18x9.5" (40) = 18x8.5 (39) then 18x8.5" (33) would be 6mm outwards in back, maybe not too bad.... man wheels are SO DAMNED hard to know till they're on!!!

True story. Just like a 17x10 +44 on my S2000. I had no idea how it will fit until I actually the wheels. The only reason why I went with them was for the Essex AP Sprint BBK to fit and for the best possible usage of the 255 tire. :thumbup:

Looking for some wheels soon? :bonk:

Ya David been full throttle on hunt for good, light squared set. Just want to see what Sema debuts then make up mind and jump on "something".

Careful, 18x9.5" (40) does not equal 18x8.5" (39).

Exactly how you mean? This all started when I was trying to figure out how 18x8.5" (33) offset squared wheels would look without spacers.

A 9.5" wheel is 1" wider than 8.5". So both its inside face and outside face are 0.5" (12.7mm) further from the center of the 8.5" rim (i.e., the rim would "poke" +12.7mm more if they had the same offset).

The difference between 40 and 39 is only 1mm, which would just shift the faces inside by 1mm.

So a x9.5(40) pokes roughly +11.7mm more than x8.5(39), and roughly +4.7mm more than x8.5(33)

...i think

Typo, 18x9.0 +45mm

The reference was for 18x9.0 +45mm compared to 18x8.5 +33mm which is a 6mm differences.

9.5 was a typo.

I'm interested to see if anyone's achieved the square fitment...

I had a square 18x9.5 +40 Advan RG-D fitment on my car. The 18x8.5 +33 will work just fine.

Thank you :thanks:

Mainly asking because I want to go with 18x8.5 +33 on stock struts (Swift springs). Hopefully it will work :)