DIY Tapturn Flasher Install with Strobe Option
 

first off I would like to thank @scottmcphee from tapturn for making this a reality..

BEST USE WITH LED TURN SIGNALS


Go to Page...
@
scottmcphee

If you have done or replaced your flasher already, you will not need these DIY for this is an actual PLUG n PLAY product.

Here is a pic of the new flasher
http://i50.photobucket.com/albums/f3...ps56e46f3a.jpg

compared to stock
http://i50.photobucket.com/albums/f3...psc8a414bd.jpghttp://i50.photobucket.com/albums/f3...ps2371f2f6.jpghttp://i50.photobucket.com/albums/f3...psdb43f20f.jpg

for the Install, pretty straight forward
you can reach under the steering wheel to install but Im showing you guys where it is located.
first I pull off the side panel on the driverside
http://i50.photobucket.com/albums/f3...psb0c68e62.jpghttp://i50.photobucket.com/albums/f3...psebf148df.jpg

there is A screw inside the panel and underneath the dash right below the ignition.. remove them and gently pull back the under panel
http://i50.photobucket.com/albums/f3...psbecd4ca9.jpg
http://i50.photobucket.com/albums/f3...ps634ea1a7.jpg
http://i50.photobucket.com/albums/f3...psbf6d86f8.jpg

now you can see where the flasher is. I use a small screw driver to unclip the flasher from its mount.. you stick it in to unclip its from it mount and push from behind towards the rear of the car.
http://i50.photobucket.com/albums/f3...ps58a4cf5b.jpg
unplug the stock one and plug the tapturn flasher and your done

end results, click on image to see the video
http://i50.photobucket.com/albums/f3...ps5fdcdf98.jpg
http://i50.photobucket.com/albums/f3...psbdc54996.jpg
keep in mind you can use this as regular Tapturn flasher and has the function as the regular flasher, you just need to swith it off, you can also flick a switch to where these function will only work with the car OFF

Photobucket sucks, videos are slow..

looks cool though

This is a 120 second mod. Lay down under dash with flash light. Disconnent cable from stock relay. Use a cable tie to secure the the new relay leaving the stock relay alone. Plug in harness. It doesn't need to be anymore complicated than that ;)

Sent from my GT-I9500 using Tapatalk

I posted up some video (on youtube) of a unit like this working in a test vehicle (my car!). Youtube shows the action a little smoother like it really is.

http://www.ft86club.com/forums/showp...&postcount=172

Send me your email and I'll email the video to you

Done

Thanks!

Strobe option...I already have a Tapturn Flasher, but how do I get one of these with this strobe option?

PM me !

same here i already have the tapturn.... sending pm