Unichip Flux2 problem/question
 

Just installed my unichip and flux2 that i got from another forum member and i have 2 concerns...

does the flux2 power off on its own eventually when the car is off? In the instructions it shows a "pwr off" button but i don't get that and it stays on for a good while once the car turns off. i just unplugged the odb2 connection for now

also while moving it around after i pulled the cables through, i noticed the cable that goes into the flux2 from the unichip has a wire that had come loose and separated from the harness. it appears to be the top left wire. i can't tell if anything's actually not working right. it gets a connection to the unichip just fine but i have no idea if there's something thats not happening that should be happening

any ideas? @Unichip Jack ?

thanks