Headers setup
 

Currently running borla catback and looking to get uel headers soon. Heard a lot of good and bad about borla headers (original plan) but still open to other brands. Going headers without a tune for a bit due do financial situation. What would go good w the borla catback? Looked into revwork which seems to be getting quite a bit good reviews. Any suggestions or experience w this?

I have the Revworks and enjoy them a lot. Remeber though that they are catless and will increase the volume of the exhaust a bit. And since you plan on NOT getting a tune, you will need an O2 defouler otherwise you will get a CEL.

That was my plan until I got my tune I will have defoulers to trick the o2. Then take them off after a tune. Just can't make them happen at the same time. Thanks for the input

No problem. Here is a short video of what it sounds like with my exhaust. Its not a Borla system, but should be pretty comparable to it.

[ame="http://www.youtube.com/watch?v=QbndvIrWGys"]FRS Revworks UEL header, Tsudo header back exhaust - YouTube[/ame]