Raceseng | 70mm and 72.5mm Innovate Supercharger Pulley
 

Raceseng collaborated Moto-East to develop small diameter pulleys for the Innovate Supercharger. We have 70mm and 72.5mm pulleys in stock!

The 70mm pulley increases boost to 11.5 psi and puts the Innovate supercharger at 15,000 RPM of continuous red line operation at 7,400 engine RPM. Expect an increase of 20-30 hp!

The 72.5mm pulley increases boost to 10 psi. Expect an increase of 10-15 horsepower!

Although the pulleys are a simple bolt on, tuning is required to optimize their performance. Mike at Moto-East (@moto-mike) is a tuning guru and is available to answer questions.

CHECK OUT THE PULLEYS ON OUR WEBSTORE HERE - http://www.raceseng.com/innovate-sup...r-s-subaru-brz

http://www.raceseng.com/media/catalo...scpulley-1.jpg
http://www.raceseng.com/media/catalo...scpulley-2.jpg
http://www.raceseng.com/media/scpulley-72.jpg

Probably better off in the Forced Induction forum, but i'm going to be ordering one of these in an hour or two!

Good point! Just added it to the FI forum.

Free pulleys for good points? Score! ;)

I thought it was possible to get a 70mm pulley from innovate. Is this not the case? If so, does that mean there is a high danger of failure and innovate will not support use of a 72.5 or 70 pulley?

Is the intercooler available yet?

I believe you can get a 70mm pulley from Innovate, they talked to us at 86Fest. I'm not totally positive on that...