FBM turbo kit help please
 

we already installed the base kit and we have problem after we check everything I flashed the basemap ecutek everything done right on flashing and now we start the car it stalls after we figure out the air mass sensor position wrong/fualty we changed/twisted the mass air flow and the car start fine after we blib it little it stalls agine and also there is check engine lights and TRC lights we loged on ecutek we trying to clear them but they wont goway anyways the big problem we cannot move the car it still stalling PLEASE I need Big help ill be much appreciate thanks..!!

Just contact LJ @FullBlown, he will take care of you.:thumbsup:

you thrown any codes?

I work at toyota corp so tell me the codes if any and i can help you from there!

sure sorry for dealy I remember two codes right now U0100 and B14A1

DTC U0100 Lost Communication with Engine Control Module (ECM)

based on that code you might want to reflash the tune see if that will fix anything.

bad flash looks like. see if you can reflash a stock map see if car runs ok then flash the base map again

might want to tell LJ @FullBlown you need another license as well
@lexusb3 what the hell is B14A1

i was told that code is a shit code something you can turn off in the tune. ITs not on the list of ENGINE Codes i have infront of me!

I have done flashed the basemap agine same problem same codes

anymore help?

Probably need to wait till tomorrow when FBM is open. Shoot them an email, I see you are in Kuwait and phone communication might not be the ideal solution.

Talked to him today, we will figure it out int he morning.

@FullBlown disreguard he was never clear on what he was using tial or precision. i will leave him in your hands