Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB

Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB (https://www.ft86club.com/forums/index.php)
-   Member's Car Journals (https://www.ft86club.com/forums/forumdisplay.php?f=40)
-   -   Pneubs HKS Supercharged BRZ Build Thread (https://www.ft86club.com/forums/showthread.php?t=40233)

Pneub 06-27-2013 03:54 PM

Pneubs HKS Supercharged BRZ Build Thread
 
Dark Grey Limited 2013 BRZ

Looks:
- Optiocoat 2.0
- TOMS Taillights
- Removed Wing
- White Side Markers w/ White LEDs
- VIS Carbon Fiber Fender Flares (Wanted to be distinctive)
- Tint front to back
- White LEDs for License Plate
- GrimmSpeed License Plate Relocation Kit
- GrimmSpeed FT86 Oil Cap
- GrimmSpeed Battery Tie Down
- GrimmSpeed Hood Struts
- Beat-Sonic Shark Fin Antenna

Wheels:
- Rota Grid Hyperblack 18" Staggered 8.5"/9.5"
- BF Goodrich KDW 2

Brakes:
- Stoptech Front BBK w/ Street Compount Pads
- GrimmSpeed Master Cylinder Brace

Suspension: Not sure what coilovers to get yet
- Racecomp Yellow Springs with bump stops
- Racecomp Sway Bar set
- Whiteline Com-C Strut Mounts
- Whiteline Reach Camber Kit
- Whiteline Rear Crossmember Bushing
- GrimmSpeed Strut Tower Brace

Sound System:
- Alpine SP60c Speakers in the front
- JL XD700 5 Channel Amp under the seat
- JL Sub Controller mounted under the steering wheel column.
- JL Stealth Box
- Lots and lots and lots of Hushmat (no more rattles anywhere)

Power/Driveline:
- HKS Supercharger Kit
- Deatschwerks Fuel Injector Kit (700cc)
- Deatschwerks Fuel Pump
- Perrin Oil Cooler
- ECUTEK Tuned
- South Bend Street Clutch
- Toyota Pilot and Throw-out Bearings
- Revworks UEL Header
- Perrin Overpipe
- Perrin Front Pipe with High Flow Cat
- Nvidia Q300 Exhaust
- Cusco Air/Oil Separator
- P3Cars Vent Gauge
- E85 FlexFuel System



Currently pushing 10psi, 279whp (from 150whp on Mustang Dyno) and 205/tq.

Work is done at Evasive Motorsports in Santa Fe Springs.


http://i.imgur.com/ifnz9cj.jpg

http://i.imgur.com/33USj8f.jpg

http://www.import-addicts.com/home/w...013/08/241.jpg

Clipdat 06-27-2013 03:58 PM

Perfection.

Bullnettles 06-27-2013 04:02 PM

Looks good, what exhaust is on it now?

ATL BRZ 06-27-2013 04:02 PM

Lovely build! I have nearly the exact same suspension setup and I'm very happy with the RCE and Whiteline stuff!

Pneub 06-27-2013 04:05 PM

Quote:

Originally Posted by Bullnettles (Post 1030163)
Looks good, what exhaust is on it now?

I'm temporarily riding with the Greddy EVO 3. Sounds good but way too loud for me without the silencers and wait to restrictive with.

Vegas Racing 06-27-2013 04:20 PM

Great looking car. Good work Pneub!

Pneub 06-27-2013 04:28 PM

Thank you. If you guys have any suggestions I'd love to hear them.

chadstyle 06-27-2013 04:32 PM

How many miles have you put on since the HKS install? What tune are you running with it? I've been looking for more info on the HKS but most people have the Vortech kit installed thus far.

Car looks like a blast to drive! Nice work.

Pneub 06-27-2013 04:36 PM

Quote:

Originally Posted by chadstyle (Post 1030248)
How many miles have you put on since the HKS install? What tune are you running with it? I've been looking for more info on the HKS but most people have the Vortech kit installed thus far.

Car looks like a blast to drive! Nice work.

Car has 2400 miles on it and 1200 with the HKS. It's tuned with the ECUTEK right now and at 9psi. The tuning isn't done yet though for a few reasons but even with it not perfectly tuned it rides great. The torque curve couldn't be smoother (except that damn dip at the end which will hopefully be fixed with those headers). Still has some idling issues but all of that will be worked out. I have zero issues with the kit and when comparing the dynos to Vortech the only difference was it seemed to bring on the torque sooner.

thill 06-27-2013 05:34 PM

I really liked what you have done. Some changes to the outside, but nothing too crazy. Which antenna is that? Well done! Will definitely check out your dyno results.

R2RO 06-27-2013 05:49 PM

Props man that is one sexy engine bay, im going vortech though :)

Bullnettles 06-27-2013 05:53 PM

Quote:

Originally Posted by Pneub (Post 1030237)
Thank you. If you guys have any suggestions I'd love to hear them.

I really like the master cylinder brace I put in. Couldn't tell if you had one or not, but it helps.

Pneub 06-27-2013 05:57 PM

Quote:

Originally Posted by thill (Post 1030415)
I really liked what you have done. Some changes to the outside, but nothing too crazy. Which antenna is that? Well done! Will definitely check out your dyno results.

I'm not sure what antenna is actually coming. I just know that it's paint matched to my car but I should see it next week. What other outside modifications would you recommend. My goal is people (and primarily cops) see my car and think "that looks nice but nothing too crazy". I'd like to change out my tail lights or have them lightly tinted. I definitely don't want to do a body kit as I think it attracts way too much attention, most of them look too flashy and unrefined, and the car is already as low as I'd ever want it going over bumps and into driveways. I'm open minded to other modifications to make it more distinctive though. I considered doing the carbon fiber mirrors to match the fender trims.

Pneub 06-27-2013 05:59 PM

Quote:

Originally Posted by R2RO (Post 1030453)
Props man that is one sexy engine bay, im going vortech though :)

Can't go wrong either way. I really like the OEM look of the Vortech and they are going to eventually have the carb sticker to go with it as well. I could have flipped a coin and purchased either one and be just as stoked.


All times are GMT -4. The time now is 11:37 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2026 DragonByte Technologies Ltd.


Garage vBulletin Plugins by Drive Thru Online, Inc.