Drivers side marker clips.
 

Hey guys yesterday I lost a one of the 3 little clips that hold in the drivers side marker assembly. I have the part number for the marker. 84912CA150

Does anyone know if I need to buy the entire thing or can I just get the clips?

I need one as well, so if you can find a place to buy let me know.

I have painters tape holding it in right now. but I may just drill a hole and hold it in with a zip tie.

I had a similar problem so I just bought one of these nylon rivets from autozone.

http://www.autozone.com/autozone/acc...nw?switch=true

Worked well!

Those wont work for these. I need the little metal tabs. like in the picture below.

http://www.jhpusa.com/store/pc/catal...markers3_d.jpg

Got part numbers. The retainer clips. 57707CA140 $6.58

and the light itself. 84912CA150 $40

So where did you buy these or find them? When I use that order number I don't get any results. Thanks for helping.

I went to my local subaru dealer ship. 6 bucks. and I dont have to pay for shipping.

Are these the metal tabs that clips inside the sidemarker housings themselves? Not the plastic pop rivets?

Sorry this ended up being a bust. You cant buy those little clips they come as part of the side marker. cost me 40 bucks for two new ones.

goddamnit.. I wonder what is a good method rather than buying a whole new set..

One of mine broke off. I kind of bent it again and then held it in place with epoxy putty. Been working ok.


Sent from my iPhone using Tapatalk

Same thing happened to mine. So I used it as an excuse to get clear ones off of amazon.


Sent from my iPhone using Tapatalk

i had some thin sheet metal laying around, i just used tin snips and cut out new clips to fit, and bent them accordingly to match, was easy. most hardware stores have some small peices of loose metal / left over scraps when people need metal trimmed down. I know at least my local Lowes and Home Depot does. $2 worth of metal, you can make 100 of these little clips.

just my 2 cents..