BeSpoke Back Up Camera Help
 

I'm following post_break's guide here:
http://www.ft86club.com/forums/showthread.php?p=952117

But I can't seem to get the wiring right. Seems like I'm doing it right but nothing shows up.

Tapping into the 12v from the acc plug in the glovebox.

try to tap a signal from a different place, i used the green wire on the amp ... as long as you have 12v in postions on acc and run you are on the money!

I'm not really good with wiring but I'm using a test light. There are 3 wires, Trigger, Video, and the 12v Power.

The 12v Power works no matter what, so I tried (with test light) to connect that wire to the "trigger wire". Test light didn't light up. Connected it to the Reverse light and it still did nothing.

So the problem has to either be the Trigger Wire (Since the BeSpoke isn't going into that mode).

Or the Video RCA since it isn't popping up (haven't tested the wire/power to the Video RCA).

Figured out what it was. The video RCA wires had to be reversed. The Ground is on Botton Left while the Positive is on the Top Left.