EcuTek racerom feature help
 

i got my car flashed today and autoblip works perfectly, as did flat foot shifting at 1st. i made a stop and when i started back up now it just revs like crazy when i try it as if it's gone (yes i'm on the correct map). any idea whats up? am i just doing it wrong and was lucky at 1st?

I think flat foot shifting only works above 4000 or 5000 RPM

ah ok, well that would b the issue then. ill have to test it out later (still need to figure out launch control too)

For launch control; make sure you are on the righ map.

Then make sure the car is stopped in neutral and your foot is off the clutch. Then push in the clutch, put it in first gear, them floor the throttle. Adjust the rpm with the cruise control stalk.

Oh and make sure the traction control is off.

that last part is what i was missing thanx. so as a map feature u wont burn clutch because i could smell it when i tried it without a tune?

If you ride the clutch it won't matter what map it's running on, you'll still smell burning clutch.

Well higher rpm didnt make a difference on flatfoot. Any idea @FA20Club.com?

flat foot worked for me when i did the 1/4 , although the launch control doesn't work after you do a burnoout. which sucks :(

for that i was told to remove the neg terminal from battery and it fixes it somehow

for me i use the cruise control nob, same steps just before i rev i pull back then rev. Is this a update where we dont have to pull back? O and autoblip revs hard when you drivin hard and touch the breaks lol. If your on that map your car runs hard!!!!!!! as for the smell that breaking in parts and the clutch doesnt burns as much once you feel out how to launch.

if you want swing back by the office and ill check it out for you. next time just pm or call me cause i didnt see the tag till now