Color options Camber Plates, Stress Bar, & Shock Mounts
 

Hey everyone, we are going to be running a new batch of Camber Plates, Stress Bar, & Shock Mounts in a single color in the near future and we just wanted to get everyones input.

The colors will be;
Pewter
Red
Gold
Blue
Other

We appreciate everyones input. :thanks:

If it is any consolation Adam I LOVE the pewter I have since my vote wouldn't really count. Looks very good under the hood without being out of place looking. Flows with the car very well. I will post pics later this evening so others can see it if you like. Still need to do my review :thumbsup:

pewter for SURE!!!

or polished with clearcoat for extra cost ;) ;) limited edition wink wink plz plz plz

Here are some cell phone shots I took real quick of the Camber/Caster plates and Stress Bar in Pewter. Personally I really like the way it sorta blends in. The setup is quite impressive looking in the engine bay without the need for bright colors. I like all the color options that are currently available and I had a tough time deciding which to go with at first but I am glad I changed to Pewter at the last minute. All the other Ground Control bits and pieces are red and yellow on my setup with the exception of Pewter on the rear shock mounts.


http://i1353.photobucket.com/albums/...ps2c20899e.jpg


http://i1353.photobucket.com/albums/...ps4133b6f5.jpg


http://i1353.photobucket.com/albums/...ps07d235d0.jpg

Come on guys help GC out. We just want to get an idea as to the color most would like to see.

I will post some different pics later today

Adam

@AZFA20 Thanks for posting! I was concerned about the GrimmSpeed hood struts coming into contact with this setup.

I think you have your answer. Pewter.

Pewter or do a limited one in wrinkle black

No problem, glad I could be of unintentional help in regard to the hood struts :happy0180: (love the Grimmspeeds by the way ;)).

Ooooh! wrinkle black would be nice with the little machined edges like all the others. Not sure how well that would work though because the mating surfaces are pretty precise so the texture of the wrinkle would have to be avoided in those areas I would assume. A couple more steps would be required for the prep I am sure.

Matte black tops, wrinkle black brace

I have the GrimmSpeed hood struts and love how effortless it is to accesss the engine bay (first appreciated it when putting in the Perrin inlet tube).

I second the wrinkle.

I voted for blue, but pewter was a close second. Blue because it would be nice in the WRB engine bay :)

Except the WRB engine bay is not WRB.

And the Winner is "Pewter". We here at Ground Control just want to say thank you to those helped with their input, we greatly appreciate it.

Thank you,