Black Subaru BRZ Corrected and Opti-Guard - TLC Auto Detail
 

Today we had another Subaru BRZ that was getting a New Car Prep, and being coated with Opti-Guard. This one is black, the only BRZ color that we hadn't worked on up until today.

As usual we started by cleaning the wheel, tires, and wheel wells, and then did a two bucket wash on the exterior. The paint wasn't super rough, but there were a few contaminants so we went ahead and used a Car Pro clay block on all the paint, glass, and wheels to make sure nothing would affect the bonding on the coating.

After all of the decon, we could see the true condition of the paint. For black it wasn't terrible, but it certainly needed to be corrected before being coated. Here is what it looked like before (sorry, the sun stayed behind the clouds all day)

http://i1305.photobucket.com/albums/...ps9dff3617.jpg

http://i1305.photobucket.com/albums/...ps3142f372.jpg

We did a few test spots and decided to go with Menzerna Powerfinish on a blue LC hybrid pad with the Rupes LHR21. Here is a 50/50 with that combo on the hood

http://i1305.photobucket.com/albums/...psc1bc3fe5.jpg

Most of the swirls were fairly shallow, but there were some very deep scratches on the trunk lid. These could not be totally removed since they went through the clear, but we were going to improve them as much as possible.

http://i1305.photobucket.com/albums/...ps6b8b8966.jpg

We first took some paint measurements to make sure we had enoguh paint to work with, and we did. We wet sanded the spot with 1500, 2500, and finally 3000 grit paper. We then polished it with M101 on a Car Pro Cool Wool pad, and then finished it with Menzerna 106fa on a green uber pad. Here is how it turned out. Most of the scratches were removed, and the deeper ones can only be seen under the lights from the right angles.

http://i1305.photobucket.com/albums/...psf7c1f467.jpg

Here is how the rest of the paint came out after the correction.

http://i1305.photobucket.com/albums/...ps9969094e.jpg

http://i1305.photobucket.com/albums/...ps5c7ea429.jpg

We did a quick wash to remove the dust and then did a wipe down on the paint, trim, and glass with Car Pro Eraser to make sure the surface was perfectly clean. We then applied the Opti-Guard to the paint, glass, wheels, and trim. Here is how it all turned out.

http://i1305.photobucket.com/albums/...psec588e7d.jpg

http://i1305.photobucket.com/albums/...ps6b3f899d.jpg

http://i1305.photobucket.com/albums/...ps852e145e.jpg

http://i1305.photobucket.com/albums/...ps94aadcef.jpg

http://i1305.photobucket.com/albums/...psbb3549b1.jpg

We, and the customers, were very happy with the results, and we were glad to finally get to work on a black BRZ. Thanks for looking, and we look forward to your feedback!

I just picked up my black BRZ yesterday, and when I took it in to get a clear bra put on, the installer pointed out quite a bit of the same light scratches you showed in the pics. He's talked me into having a detailer polish the front end before he puts on the clear bra. Now that I see your pictures, I'm confident I'm doing the right thing. Thanks for sharing! That's impressive!!

Thanks, and good luck getting yours done as well!

Dang Dave you are busy! Great job man!