Pm'd

Either OP or anyone else selling a set? New or used is fine.

If no sellers, I'm willing to start looking into having a machinist make a batch as well. Preparing for snowboarding season :D

Located in Ontario, Canada

I’ll have a set available as of the end of August. My lease is up in mid August.


Sent from my iPhone using Tapatalk

Also looking for a set
 

I'm also looking for a set of these rods. If anyone is making a run or has a good used set I'm interested.

Im interested in these too!

I'm interested too! @that_guy, any chance you have the pictures somewhere that you could share, the originals are gone.

Selling my setup now if anyone is interested...

https://www.ft86club.com/forums/show...31#post3346731

Is your setup still available?

I hate to be the bearer of bad news, but I ended up buying the bike rack and tow hook attachments from Matt. [IMG]https://uploads.tapatalk-cdn.com/20200722/798a27d1***6e013b856f4ed63a9e620.jpg[/IMG]

Sent from my SM-G970W using Tapatalk

Thanks for the reply. Looks like I get to start trying to fabricate my own haha

Is anyone able to give me the width of the groove that the rack sits in?

The groove is only as wide as the locking clamp on the tray. There technically doesn’t need to be a groove if you have everything clamped down well.

I’ll see if I can dig my clamp up. I have converted my 1up to a hitch mount for my 4Runner.


Sent from my iPhone using Tapatalk

Yeah, I plan on using a 1up rack as well and figured I might as well get the groove machined in as long as I'm getting them made.

So I did some measurements. 32 mm for the groove and 26 mm for the bracket from 1up USA. I would recommend asking 1up USA for the bracket size as the dimensions may have changed over the years with minor revisions. The rack is several years old.https://uploads.tapatalk-cdn.com/202...4a05d11019.jpghttps://uploads.tapatalk-cdn.com/202...29fc3cd62a.jpg

Sent from my SM-G970W using Tapatalk