Dual Catch Can, hoses and fittings
 

I need to install a dual catch can system soon. The need of a catch can has already been :reposthorse: (beaten to death).

Since there is such a limited amount of options for us, I may have to go with a universal system. From this DIY, I got the hoses and fittings needed for the PCV valve side.

Now, I would like to know what fittings and hose sizes are needed for the breather side.

http://www.ft86club.com/forums/attac...1&d=1354232583

Thanks!

I think that side is 1/2" or 9/16" ID. Pull off the easy to reach one and measure. Hopefully the other side is the same I haven't checked down there.

I can check my D3PE instructions when I get home tonight.

I know I know.... I'm being a lazy ass for not measuring them myself lol. I was just hoping someone had already measured as to not reinvent the wheel. :-D (yes, that is lazy too).

Hopefully D3PE show measurements in their instructions.

Sent from my HTC One X using Tapatalk 2

Please let me know ASAP.

Thanks!!

Sent from my HTC One X using Tapatalk 2

Man I completely forgot to check last night. Sorry.

Looking forward to the install, I have a dual catch can that I never installed in my old Evo IX.

Don't worry, as soon as you can is good!

The D3PE catch can uses all 1/2" barbed fittings. The hose coming off the back of the intake manifold starts out at 1/2" and then gets smaller and the hose connected to the intake in the front is all 1/2". I like McMaster-Carr for all my fittings.

Could someone please do a dual catch can DIY