BRZ fog light removal for tint. how?
 

I guess this is more of a BRZ specific question.
I want to make my BRZ fog lights yellow. How do i do about that? Do i need to remove the fog lights and apply the yellow film on the inside?
I found a lot of posts about tinting tail lights but nothing about BRZ fog lights.

eaiser way is to change the bulb.....buying from this eBay: http://www.ebay.com/itm/2013-SUBARU-...6b45a1&vxp=mtr

Are these bulbs new? I have been waiting for bulbs where I don't have to shave some of the plastic fitting. Do these overheat at all? Any issues?

Also for the yellow tint, I've got a guy who normally does overlays do it, and he did it while the fogs were still in, no removal needed. I will add some yellow bulbs as well to make it even more yellow.

https://www.dropbox.com/s/soqli629j0...%2007%20AM.jpg

https://www.dropbox.com/s/8rrqsb27xa...%2047%20PM.jpg

thats the look i want. how do u do the overlay?

Try this guy Chenshuo

http://www.ft86club.com/forums/showt...hlight=bluebat

Yeah purchase the tints from bluebatmobile and if you don't feel confident installing them, I suggest getting a wrapping/overlay vendor do the install. That's what I did. I used Precision Dynamix in irvine

I have authorized installers around the country:). Email me to order ;)

B@t

Can i get the whole fog light assembly out so i can replace it with Yellow fogs Without taking off the bumper?

I think that would be possible after removing lower plastic cover (between bumper and engine cover)

yes u can. u gotta peel back the fender liner after popping the 3 (or so) tabs. there are a couple screws u access from the rear of the units. unplug the wire harness from the unit (fog light) before u do the screws.

no the film goes on the outside. u need to follow similar directions for replacing the fog bulb (to access that area from the wheel well), but just remove the screws and take the whole unit out. use a little water on the clear curved part of the unit and a hair dryer to help spread the wrinkles out.