speed bumps
 

just curious,is anybody having problems with clearing speed bumps in apartment complexes,and other places?

nope. its got a good 5-6 inch clearance, and no reasonable speed bump should be that high. watch out for curbs tho >.<

According to my brochure it's 4.9" and that should be enough.. I was under the impression speed bumps were suppose to be 3 inches or lower.. Thought I read that in the California drivers hand book.. Could be wrong though.. What ever it was in stated it was a national thing, and I've seen shaven bumps before

Just don't hit them at 50 mph!

Already had a few scratches below the front because of in/out some parking lot curb...ouch!

if you're worried about scraping, approach it at an angle, slowly.

For more info (though I just about summed it up right here):
http://www.ft86club.com/forums/showthread.php?t=22507

You didn't have "speed bumps" instruction in you driver's training class?

no! not in '66! no need! people
walked back then! lol!

No issues with speed bumps here, just one small scratch from entering a Burger King in Boston.

I never tried actually driving THROUGH a Burger King..

A lot of them here in Belgium, but no, never had problem with them

I find the front bumper perfect height to just clear most parking curbs. Any lower and I'd slam right into them! Speed bumps are fine, but I take them at an angle at a crawling speed just in case.

And I think that measurement uses part of the rear LCA as the low point - so you'd never be in danger of dragging it over a bump, as it will rise with the wheel.

When I installed my Borla, I went around measuring clearance, and in stock form I think the static GC is closer to 6 inches.

Our car is lower 2 inch so, can't do speed bump