T1R Over pipe and Front pipe !
 

Hello everyone,

Introducing out T1R over pipe and front pipe for MY13 BRZ / FRS.

http://www.aj-racing.com/ajpwr/BRZ/ZC6TP.jpg

- Made out of stainless steel
- 63mm piping (2.5")
- lightweight design
- NO CEL
- Will work with most aftermarket exhaust and stock exhaust
- RACE USE ONLY !

Installed pics !

http://www.aj-racing.com/ajpwr/BRZ/TP1.jpg

http://www.aj-racing.com/ajpwr/BRZ/TP2.jpg

http://www.aj-racing.com/ajpwr/BRZ/TP3.jpg

DYNO:

http://www.aj-racing.com/ajpwr/BRZ/Z...TPOPvs70RT.jpg
Above is the dyno comparison from Stock + T1R 70R single exhaust vs T1R HBE (Header Back exhaust)

+5.7whp / 6.7WTQ at 3950rpm
+1.7whp / 1.2WTQ at 6250rpm (PEAK)
--------------------------
http://www.aj-racing.com/ajpwr/BRZ/ZC670RTPvsstock.jpg
Above is the dyno comparison from Stock vs T1R HBE (Header Back exhaust)

+6 hp / 8.2WTQ at 3950rpm
+7.9whp / 4.8WTQ at 6500 (PEAK)

--------------------------

The Over pipe only made average 0.2-0.4whp over front pipe + Cat-back exhaust, we decide to release the over pipe together with out Power Header later this year .

The T1R Front pipe (NON-RESONATE) will be available in FEBUARY 2012 amd will be priced at $195CAD/USD

- Ben @ AJR

From I have been reading online, the over pipe doesn't make too much and it's pretty costly. I think will wait for your header and get the over pipe at the same time.

Are you planning to make the front pipe in 70mm ? I saw there's a resonated pipe in your pic, is that going to be available too ?

^^^ I am also interested in the resonated front as well as the OP. I hope I didn't miss it - but is there a GB for this?