0 offset Works XD9 (allmost)
 

Guys I have a set of Works XD9, they were previously for my 350z so the offset is really crazy on the BRZ, Front is 18x9 +22mm, Rear is 18x10 +18, what I have to do is get the 15mm lug conversion spacer from Project Kics and install them to all four corners, The original offset of the wheels will become near 0, FML.

Spacers will arrive tomorrow, I will see how bad this 0 offset is. The thing is I don't want to give up the wheels they are really nice.

when it is done, the car will look like an UFO, which it is pretty much against the will of the car, he was meant for handling.

Or I have to get get the wide body kit to fit the wheels

Give up now... With camber you could make it work if you didn't need the adapters, but that extra 15mm is going to take it too far.

Don't do it!http://3.bp.blogspot.com/_A0-f3c5teN...0/ricer2qk.jpg

LMAO, this is what i have in mind with the spacers, Front will fit good, but the rear will sticks out so hard

I would like to see a test fit with them just to see how much they stick out...

had 0 offset rims on my supra a while ago... liked it a lot, but don't think it will fit on the twins.
http://www.monchar.com/images/member...54655_1734.jpg
http://www.monchar.com/images/member...49116_1734.jpg

Yeah, I will do test fit for sure, I don't to give up now jet. I have to see this UFO in person to give the project.

Front might work with a butt load of camber. And I mean A LOT. About 6 degrees give or take. Rear isn't going to work. Sorry buddy. For reference, the car below has a 18x10 +12 set up in front, 18x10.5 +17 w/ in the rear, with TONS of camber. He also says he has a lot of clearance issues. I don't know if it would be worth putting the rims on.

http://cdn2.mkimg.carview.co.jp/mink...t=5be04f8e67a1

http://cdn.mkimg.carview.co.jp/minka...6f2a9517a0.jpg

Very nice info to know, it is very helpful, and it does hurt my feeling. :mad0259:

Rocketbunny?

I have a set of factory r33 gtr rims I wanna run. With a conversion spacer it would be 17x9+15. Does anybody have pics of this fitment on a brz/frs?

If it wasnt dropped to the floor I think this would look pretty good. I think that he should go ahead with it, and see how it works out. The pics above are pretty flush or barely poking a bit, and I bet the clearance issues are more from the drop than the rims themselves.

Larryw that frs is pimp

how did you come up with the zero offset?

Front is 18x9 +22mm, Rear is 18x10 +18, with 15mm spacer, you will now have 18x9+7, 18x10 +3