Wheel Directory: Racing Hart CP-F 18x8.5 +45
 

http://www.darrendriven.com/ft86/title.png


18x8.5 +45
RacingHart cp-f tune, gunmetal, forged 2pc
w/ spacers, +30F, +28R

http://farm9.staticflickr.com/8505/8...fb02d713_z.jpg
cranberry fr-s by jszumita, on Flickr


http://farm9.staticflickr.com/8354/8...908d5d2b_z.jpg
gloomy by jszumita, on Flickr

http://farm9.staticflickr.com/8048/8...262b4b99_z.jpg
gloomy2 by jszumita, on Flickr

http://farm9.staticflickr.com/8194/8...30ae7e5d_z.jpg
close-up by jszumita, on Flickr







the kics r40 neochro look amazing in person, also.

Sick looking wheels. Can't wait to see them mounted

Niceee! get those on and take some pics!

Love em! I was actually eyeballing this set but they are to close to my old SSR Professors. Can't wait to see the pics!

I like these too but wish they had center caps, i'd probably run about a 10mm spacer too at least on the rear.

Been a long time since I've seen Racing Hart stuff. Where'd you get them? They look nice!

They sure are pretty.

Nice, I used to have a set of these on my WRX a few years ago. I didn't think I would see another set around again.

Have to see it mounted on but wheel itself is freaking beautiful. Good choice brotha

I have the same wheels that also came without center caps. I own a machine shop, so we used some remnant stainless bar stock and machined some bushings to fit the factory center caps into the Racing hart wheels.

We also had to enlarge the valve stem holes for the TPMS sensors to fit.

i will be running a 3mm up front, and a 15mm in rear to start. on the search for center caps, some will come up one day im sure.

stumbled across them on ebay believe it or not.

thanks for the info, will have to keep that in mind with the TPMS.

got them via fedex today, should have them mounted up tommorow!

http://farm9.staticflickr.com/8224/8...9df7cb38_z.jpg
kicslugs by jszumita, on Flickr

http://farm9.staticflickr.com/8219/8...54189c16_z.jpg
racinghartside by jszumita, on Flickr

http://farm9.staticflickr.com/8078/8...6f0136cc_z.jpg
racinghart2 by jszumita, on Flickr

http://farm9.staticflickr.com/8356/8...6c2051bd_z.jpg
racinghart1 by jszumita, on Flickr

Can't wait to see it.

need some help,
where the valve stem is on these wheels, the diameter on these are smaller.
you cannot fit a oem valve stem or tpms thru. i have never heard of, or realized this on any other wheels ive had.

solution?
-need bolt in valve stems that are no wider than the thread of the valve stem, cant seem to find any.

-drill the hole very slightly and fit new tpms in. (it is very very slightly too small)

i think a slight drill would be better, and i could use tpms