DIY Request- Removing Beat Sonic Antenna
 

Does anyone know how to remove beat sonic antenna w/o harming paint. Any tips and tricks would be great. Also the reason why i am removing it is because i will be installing a modelista antenna pretty soon. Thanks!:thanks:

heat up the sides then just wiggle it, and it comes out

Im pretty scared of using a heat gun after i saw what happen to the paint on my friends car on trying to remove his emblem... If you dont mind me asking what would be a affordable heat gun that i should look into?

i just use my hair dryer at home! :thumbsup: works just like heat gun without the excessive heat

Hope i dont use it at the wrong time so the wife dont scream "wheres my hair dryer" :mad0259:. Thanks for the tip :D

Your friend overheated the paint and melted the plastic (the emblems are sitting on plastic bumper and trim piece)

The place you are heating is metal; so it will withstand the heat better. :)
Just be careful of melting the fin... and perhaps the antenna base underneath it... (don't recall if the base was metal or plastic)

Good luck!

Where and how much did you get the Modellista shark fin?!?!
I MUST KNOOOOW >.<
I've been craving it forever

She probably won't scream as much as my wife when I baked my headlights in the oven to black them out lol

your wife reaponse "where the f&*k is the f%*king turkey!" lol:thumbsup:

Hahaha. I couldn't even picture the look on my moms face if i did that... haha