I found these wheels on a mustang site. would they work fit the FRS
 

http://www.latemodelrestoration.com/...SVE-Drift-18X9

http://cdn.lrsstatic.com/layout/images-v2/spaceball.gif

You might need a bit of negatice camber and possibly rolled fenders, depending on your tire selection. My wheels are also 9" wide but +28 offset. So these would stick out an additional 4mm. Not a ton, but I'm already close to rubbing in the rear.

I've got 235/45 Federals on mine, and those run a bit wide. Something like a 225/40(or 45) would probably be fine for these wheels, or even a 235/40 in a less meaty tire.

*Note: my +28 wheels are sticking out a ton in front, but no rubbing. However, I do not plan to keep these on the car so I haven't done anything about front camber. It just looks goofy for now.

Wrong bolt pattern but there are tons of wheels out that look like that.
http://www.nlmotoring.com/XXR-530-wh...p/53088102.htm

these are in 5x100 correct bolt pattern. look the same. probably better fit as well

http://www.nlmotoring.com/XXR-530-wh...p/53088102.htm

Ah! How'd I miss that?

Conversion spacers would stick these out way too far. They might fit my 'stang tho.

They're both really heavy wheels tho.

I love the way those wheels look I just dont want to get something to wide and I dont want it to sit under in the rear I also dont want it to stick to far out I just want it to look flush with the fenger in the rear. thanks for the links guys I hope those are not to wide for the front also the price isnt bad either

5 x 4.5" is the equivalent of a 5x114.3

No.

bingo. ugly. heavy. cheap.
enkei makes a wheel that looks similar.

http://www.ft86club.com/forums/showthread.php?t=18661