^^^ You running corn??? good luck

Looked like no help today for Eric but Corey ended up 3rd about 1s back. What was going on with the car?

Looks like Andrew pulled out the win with his final two runs. His winning last run he had a 2.5 60' so he must have been going for broke on course. It looks like he had the worst 60' times in the competition, you guys were running pretty consistent low 2.1s.

^^^ You saw that too very Close/exciting battle.. Congrats on Corey getting the final trophy spot

Bill

The car had a bad push mid turn, and loose on throttle. We were way off of Andrew and Jeff. I had a lot of 2.1 60 ft, it wasn't a true 60ft though. I made it to the final 2 in the bonus challenge, I had a 1.2 second lead lead going to the other side and I broke out. Like a dumb ass, I hit a cone in the slalom and finished 2nd.

Congrats to Andrew on the win.

Simmons

Are you running the KW stock spring rates? If so, did you swap the springs front to rear?

When you get that header on i want to meet up with you man!


Sent from my iPhone using Tapatalk

Great build! Thanks for sharing!

Yes, swaped front and rear.

Simmons

Simmons

Definitly, I will let you know when it is in.



Simmons

Thanks man you think its going to be this week?


Sent from my iPhone using Tapatalk

It won't be here until Friday, hopefully putting it on Saturday

Where you racing sunday? ;)

Are you liking the springs set up that way? I'm trying to decide if I want to do the same or buy new springs.

I like it this way.


Simmons

Simmons

When can i take the ride to pa to see them?!


Sent from my iPhone using Tapatalk

I am installing it tomorrow night, so sometime after that, I might go to the MSNE event on Sunday.


Simmons

No Dover?

No Dover for me, it is too bumpy.

Simmons

Simmons

Simmons

What does the butt dyno say?

Nice pieces, saw the other thread on them.

Does your car sound like a Subaru now?

I always test the car at AutoX speed 30-60, there is a nice gain :-)

Simmons

Yes 100‰


Simmons

Case in point. :)

[ame="http://www.youtube.com/watch?v=5wnPsOiDO48"]Subaru BRZ/Scion FR-S UEL Header by JDL -- Testing by Moto-East - YouTube[/ame]

Any pics of the Raceseng pulleys installed?

Simmons

Which pulleys re those? As in alternator powersteering, etc. Also whee from and how much?

Sent from my HTC One X using Tapatalk 2

Alternator, Idler, Water Pump, Crank

They are from Raceseng.com

Tell them I sent you :)

Simmons

Damn, that header sounds good. A header of some sort will be next purchase.

Do you feel any difference?

Sent from my HTC One X using Tapatalk 2

Definetly, big difference.




Simmons

Video from todays event.

[ame]http://youtu.be/KBKwS4ME2JY[/ame]


Simmons

Car sounds awesome. Throttle-on oversteer a bit?

:thumbup:

Please describe it a bit of you don't mind. If you did it already please let me know which one.

Sent from my HTC One X using Tapatalk 2

Here is some video from the outside of my Very loose BRZ

[ame="http://www.youtube.com/watch?v=csa0Cs--wzc"]http://www.youtube.com/watch?v=csa0Cs--wzc[/ame]

Simmons

Just caught up with the entire journal. Lovin it! I'm itchin to get my beast done.