Firewall Plug for noise generator
 

Anyone know the size plug or have a link where I can buy one. This is a plug for the firewall side of the noise generator.

Thanks in advance and sorry if this has been discussed!

Just take the little plastic elbow out of the grommet and find a rubber cap that will fit over it and put it back in. I bought the delete kit from Dynosty but after i got it realized it was overpriced for what you get in my opinion. I still like it better without though so i guess it was worth it.

Some one else posted this and it worked great, Home Depot or Lowes and get a PEX 3/4" plug, cost about $1.

Is in the plumbing section near the copper.

Another thing you could try if the above idea doesn't strike your fancy... Hit up your local bicycle shop, and get a pair of plugs for mountain bike handlebars. Some have a rubber plug that expands and locks into the handlebar when you turn a locking screw. This type should only cost a few dollars and make for a good water/air tight seal.

if I just plug the firewall will affect the performance?