"Carbon Fiber" dash piece
 

Well it finally happened, the so called "carbon fiber " :laughabove: dash piece got scratched. Went to the scion dealership and the piece runs about 50 dollars. Decided to go to auto zone and see if they had any cheap vinyl wrap. 15 dollars later half way done and i must say it looks alot better than it did before. Ill post pics when i am done.

Pikchurs

I plan on using this cover to place my A/F sensor gage in it

i think i am going to flock mine, same colour as the alcantera. mebbe..
or leather wrapt it.. mebbe..

I do not believe it's intended to look like carbon fiber. It has the same pattern as the instrument cluster, which is more of a "scale" look...

Pics or it didnt happen

ill post pics tonight, got to finish getting them stupid bubbles out

http://i1261.photobucket.com/albums/...1/2ca33a8e.jpg
Almost finished, just need to work some bubbles out and im on my way. Getting past my bed time though :happyanim:

Nice! I hate bubbles.

hair dryer heats up the vinyl, but puts air under the vinyl. Loose/ loose situation but i guess i can handle a few bubbles.

The vinyl was positioned backwards.. Should be shinny the other way towards the right of the picture
but other than that looks good

nice! im about to do wrap my trim pieces over this weekend too. any tips?

Bubbles are only good....................

I tried it the first time without a hair dryer and it looked terrible. Tried it again with one and it works wonders. Then i took a razor blade to get the bubbles out. Cost me 15 bucks so im happy