![]() |
3D printable brake duct/fog light replacement
I've made in CAD, a duct that mounts in place of the fog light. Fastens in place the same way as the fog light for fairly seamless fitment.
The back side has a 3"/76mm diameter barb for connecting any hose that size. Also two small beads to lessen the chance of the tube sliding off. But I would still use a light duty hose clamp. I still need to make the the other end that points towards the brakes. But no promises on being able to do that too soon. https://www.printables.com/model/135...duct-toyota-86 |
Quote:
Great part. This is a key piece for sure and it works great. Thanks for sharing it. |
Thanks. I’d made a blank fog light replacement and posted over in the cosmetic mods section and thought I’d make a ducted version. Didn’t realise someone already made some.
|
| All times are GMT -4. The time now is 05:03 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
User Alert System provided by
Advanced User Tagging v3.3.0 (Lite) -
vBulletin Mods & Addons Copyright © 2026 DragonByte Technologies Ltd.