Originally Posted by OrbitalEllipses (Post 521277)

The pocket just pulls out by hand for the button install, yeah?

Originally Posted by Sutty (Post 439587)

I finished off the CF Vinyl wrapping today.

First of all I tackled the steering wheel plastic.
I removed the airbag using this DIY tutorial:

http://www.ft86club.com/forums/showt...airbag+removal

Thanks @Synack

The only slight difference I found was that there were only three holes in the steering wheel (3, 6 & 9 O'Clock).
I used a thin bladed screw driver and managed to push on the 'spring' first time. I needed to release the springs at all three holes to get the airbag to come off. Also I didn't bother disconnecting either the horn fuses or battery, I only set the horn off twice (once during removal, once during fitting). I also left the wiring connected to the airbag and simply moved it out of the way to access the screws.

Upon removing the airbag there are two screws that you need to undo at the 3 and 9 o'clock positions

Attachment 15183

Upon removing these two screws there is a clip on the lower spoke of the plastic but this pulls out very easily.
This is the plastic removed from the wheel.

Attachment 15184

This is what it looks like after about an hour of heating and stretching, heating and stretching, heating and stretching - you get my drift and reinstalled.

Attachment 15185

To refit the airbag into the steering wheel after replacing the plastic I found that one good push on the airbag/horn clicked it right back in to place. No problems.

I also tackled the two upright pieces of plastic either side of the HVAC controls again. Last time I got too frustrated trying to remove the panels that I put the vinyl on with the pieces still in place. Suffice to say I wasn't satisfied with the result so I tackled the removal of the panels again using this DIY tutorial:

http://www.ft86club.com/forums/showthread.php?t=13583

Thanks @Trojan_SC

The only difficulty I had with this was getting the USB/Storage Hole/Starter Button Panel out. In the end I ended up pushing out the USB port, as this is all I could touch with the limited amount of room behind the panel. Upon removing the USB port I disconnected the wiring, pushed the wiring back into the centre console and then hooked my finger through the empty USB hole and managed after a couple of attempts to get the part out.

Attachment 15186

It is held in by 6 rather large tabs, one of them sustained a small amount of damage coming out (centre one) but it did re-engage fully upon replacing it.

Attachment 15187

Looks 100% better and no more tiny little bits of silver showing where I over cut during my first install.

Part of removing the USB/Storage/Starter meant removing the gear stick surround again. I found the easiest way to remove it from the console was by putting a trim removal tool in here:

Attachment 15189



I'm really happy with how it all turned out. The only slightly disappointing piece is the gear shift knob as it is really difficult to trim the vinyl around the top silver disc without either nicking the leather or cutting it too much and exposing some silver, but I am going to be swapping this out for a TRD one anyway.

Originally Posted by Honeydew (Post 889502)

Hey sutty how did you remove the ones around the center console?