Dash Cam Install
 

New here... just thought this might be of general interest.


Subaru sells a wire harness H501SAJ010 for Gen1 BRZ that also fits Gen2. It connects to the 3-plug wire harness (for optional port-installed auto-dimming/homelink rearview mirror) that sits just above and to the rear of the overhead compartment. (To access, watch videos for installing auto-dimming mirror.) For roughly $10 you will get the proper wire harness.


The white plug connects to the harness... the black one is useless here, cut it off. The STRIPED wire is ACC+ and the black wire next to it is NEG-. Ignore the 3rd wire.


Amazon sells little Buck convertors for 12VDC to 5VDC USB: 2 for $10. Connect one with butt-connectors to the plug. On the other side use whatever USB cable you need for the dash cam. In my case, my VIOFO A119 needed a USB-A to Mini-B connector 2-3ft is plenty long.


The whole power installation fits neatly above the overhead console.


If you do get a VIOFO A119, a couple of notes:
1) The GPS module attaches to the windshield, but lets you simply detach the recorder itself... very handy (and uses a straight in cable, neater than the otherwise 90degree option).

2) The ideal spot is to the immediate right of the mirror stalk. I installed mine a little farther away thinking I needed access for the SD card. That was a mistake, the whole camera detaches readily from the GPS mount, so snug it up next to the mirror.


Cheers

I’m gonna shamelessly self-promote a bit here - i sell these ready-made for $25 :)

https://hachielectronics.myshopify.c...rror-connector

Do you sell a version that splits the port, so those with an auto dimming mirror can add a dash cam?

I have some connectors to split the port at the mirror end rather than at the 3 pin, but i’ve not built them yet since i’ve been occupied with other projects. The OBD2 port option will work for this purpose though, as long as you have a hardwire kit for the dashcam.