PDR access point for rear quarter panel?
 

I'm trying to sync up with a potential PDR technician on where he should gain access to the following two dings:

https://i.imgur.com/8RupLOE.jpg

In most cases, the access point would be through the nearby wheel well by removing the wheel and underside liner. However, when I look at the skeletal structure of the FR-S (linked below), it seems that the well is completely surrounded by a metal arch. So does that mean holes need to be drilled into that arch to gain access?

FR-S structure:
https://i1.wp.com/fethiyeotoeksperti...il-Kaporta.png

I think if you remove the inside rear interior on that side you will have access to it. It is not hard at all to remove...Google

22R

^ +1