Using Open End Lug Nuts/Center Cap Recommendations for Wedssport TC105X
 

Hi All,

So I recently just put on my Weddsport TC105X with some open ended lug nuts (yes I should have bought closed ends) from Project Kics R40 (16+4 Locks) - 12x1.25. I was wondering if I should be worried about rust on these living in Northern California or if there is anything I should do before washing my car or after I wash my car to prevent rust from happening.

I'm also running the wheels without a center cap and I know a lot of people say this is fine but wondering if I should buy some center caps and if I should be worried about rust there as well.

Get some Weds center caps with integrated hub centering rings.

Type-D 65mm > 56mm - Part Number 52904

I am running the same setup. For the lug nuts I use anti seize copper grease. If you don't, the rust will stain your wheels. I painted the hub with vht black caliper paint and prefer that look to the hub center caps.

https://www.repco.com.au/en/oils-flu...005/p/A9307309

https://www.vhtpaint.com/high-heat/vht-caliper-paint

You may be on to something with the VHT caliper paint. center caps for my wheels are non-existent as far as I know (SAR V.2) and I just never seem to get around to taking measurements to have someone 3D print some.

been running tc105n with open mutegi sr48s + long arp studs for the past 7 years, Texas and Colorado. they are fine. I did end up picking up the wed centercaps cause i wasnt happy with the open center look
https://i.imgur.com/Rdi6wuA.jpg