Front Fitment Question
 

Hi! I'm new to the forum so I apologize if this is a stupid question lol. Currently I am running 18x9.5 +35 squared with 225/40r17 tires. I'm looking to also get a set of 17s to use for skids. I was thinking of running 17x9s in the front and 8s in the rear. My only issue is the 17x9's that I was to run in the front only come in 5x114.3 and already have a low offset (+15). With an adapter, is there any way I could run these in the front with more camber. I was also looking into angle mods down the line so would that help? Thank you so much!

17X9 +15 is going to require a hilarious amount of front camber.

Right on. I just couldn't find much online. Looking up a comparison of my current setup vs the new ones with adapters it looked like about 1 1/8" more poke from where I'm at now. I planned on shooting for about -5 degrees of camber in the front but I still think thats far too much poke for stock body. Thanks a ton for the help though!!

This is 17X9 +35 with -3.6 degrees up front for reference. Not a great pic but you get the idea.

https://uploads.tapatalk-cdn.com/202...4467bc352e.jpg