Spacer sizes???
 

Just bought my 2022 today. Should arrive (out of state) on Friday.

Already have suspension ready for it. In the short term, until I figure out my wheel and tire setup would like to put spacers on the car. Anyone have an idea of sizing??

I intend to install 10mm in the front and 15mm on the back (slip-on spacers). Since i don't want bolt-ons spacers. Need ARP extended studs too.

With the old car it was 20 and 25mm for flush fit. I'm not sure if that will be different on this new car though. I know the new wheels are a half inch wider, but I'm not sure if the track is wider. Hopefully someone can chime in on this.

This is the way.

Yes its been confirmed that the rear track of the car is wider but don’t have exacts. On my previous pp (7.5” wheel) brz I ran 25mm on all 4 corners (no poke).

Ok so after messing about with a few different setups. I landed with a 30mm F (25mm F works as well but not as flush) and 20mm R.. Flush fitment. NO POKE!!

So in theory, for a flush fitment with stock wheels of 7.5" the fronts would have an offset of 18, and the rears and offset of 28?

Nice, got any photos? I will be going down this route.

Finally, i ordered 20mm at four corners. 25mm in the rear seems to poke a little.