Frs OEM hanger locks. Part number help?
 

https://ibb.co/jkWkfX7
https://ibb.co/RzYBfxP

Hi,

I was wondering if anybody know the part number for the exhaust hanger locks. The one that is put at the end of the rubber hangers to secure the hangers in place. It’s a circle lock with hex screw. My was rusted so I need to replace and I’ve installed Perrin hangers. I went to the Toyota dealers today and they can’t seem to find the part for it. They even told me it might not be oem part but I brought the car brand new from them. They show me the diagram which doesn’t include that part. I found it really strange that this part is not listed. Thanks for the help. I’ve included a picture of the part.

@evolution415 Your picture doesn't work.


Never heard of hanger locks. My hangers just well... hang there.

The shape of the rods themselves keep the hangers from slipping off.

Perhaps somebody added a hose clamp for peace of mind?

https://pasteboard.co/PvLf8uikOWDg.jpg

https://pasteboard.co/Wd7mG5NevqDj.png

Thanks for the reply EndlessAzure. I posted the picture again. Yeah, I found it strange that the diagram don’t show it. I brought the car brand new from the Toyota dealer and it came like that already. I’ll take picture of it tomorrow under the car with the two locks that is still on. Like you said, the hangers don’t seem like it would fall off by itself, but with those lock I guess it keep the exhaust from moving around. This is on a 2015 frs. Don’t know if they start adding it on those models and up.

I think I figure it out. It probably from the Perrin exhaust kit. The oem doesn’t come with locks. I didn’t remember it come with the Perrin exhaust but from the look at the metal connecting to the hangers it might need the locks as it don’t have the end part like the oem exhaust.

Update: I contacted Perrin customer support and they were nice enough to sent me free replacements at no cost.

For anyone that need it. The part number is X-AMP-EXT-107 - Shaft Collar 3/8"ID. You can technically use any 3/8 collars.