Ecutek boost control help
 

So after my very old school apexi avcr died, I decided to just wire it into the cpc/evap port and enable boost control but thus far it hasn't responded to any adjustment and still is boosting at spring .4bar. Now I haven't eliminated that the apexi solenoid has shat the bed, but I put in some very basic info and have been slowly adding duty to the tables but still nothing, I have my targets set to 2.42 (1.42)but it hasn't gotten anywhere at all 😞
So searching for some advise on setup on the tables

Thanks

Have you looked at the EcuTek help files?

Mac valce \ boist sloenoid might be stuffed , try runnin a line from vent Port on valve ( asduming its a 3 Port , to cabin so you can hear\feel if its venting under boist wgen energized