Delicious tune OFT flex fuel kit
 

I just moved to a house that have a E85 station here in SoCal so finally going to get the flex fuel. but OFT stop selling their kit so had to get a Delicious kit for my 2016 FRS. Has anyone gotten this kit and installed it and can share instruction?

https://youtu.be/Kl06K2QpYF4

Sent from my SM-G781U using Tapatalk

I have that link already. but it's for ECUTECH version. I heard i need to hook up evap sensor if i want to run OFT tune. Also my unit came with a red wire and the instruction doesn't show what to do it that wire.

There is no EVAP version.

I installed my delicious tune e85 kit and dont recall any red wire just 2 plugs one to the second 02 sensor and one to the e85 kit but there again im not doing the oft

delicious have this one that has flying lead for evap connection




https://www.delicioustuning.com/OFT-FlexFuel

ive tuned a few guys on oft flex using the deliceous kit


https://www.delicioustuning.com/OFT-FlexFuel


or other zetronics flex kits .


you can convert the rear 02 kits to evap jist cut off the rear 02 plug source 12v via a fuse tap source a ground\earth and reroute the sensor wire to evap on ecu Connector A34 pin 20 as per the oft fftek flex kit instructions


also Xero limits tuning make a full plug and play evap flex kit


https://www.xero-limit.com/xero-limi...gt86-evap.html




Note oft flex tune only support pre facelift cars after 2017 you need ecutek can do that as well

Is this what the red flying wire is for?
For OFT, this kit features a flying lead wire that is to be routed through the right side firewall. The wire inputs ethanol percentage into the ECU via the CPC input wire located at the ECU harness this can be tapped via the included wire tap.
know where i plug into on the ECU side?

goes to connector A34 Pin 20 on ecu that's evap input see the oft fftec flex kit install guide