Faulty Fuel Gauge
 

Good day

I have a 2013 GT86, I recently completed my engine swap (3SGE with a EMU Black stand alone management) I noticed my fuel gauge does not read accurate. After doing some research I replaced both sender units and I still have the same problem, the only way to check my fuel level is to disconnect the negative terminal from the battery for a few seconds and reconnect the battery.

has anyone have this kind of problem before?

thanks in advance

How is it not accurate?
Dose not move at all?
Shows empty at half tank?
ECT.

sorry I should have stated the following, so if I fill up the car the gauge would show the correct fuel level and when I drive for a while the needle wont drop and in order for the needle to drop I would need to remove the battery and reconnect again after a couple of seconds to show the correct fuel level.

Try posting in the “engine swap” section, someone most likely has run into the same issue.

https://www.ft86club.com/forums/forumdisplay.php?f=92

Start here, go to post #101 and read through.

https://www.ft86club.com/forums/show...t=90692&page=8

thank you gents