Originally Posted by finch1750 (Post 3396816)

So I spun a bearing and recently bought a used motor. It came from a 2016 with 57k miles on it but when i inspected it after delivery it had a 13-14 engine harness and coil packs so it looks like the car it came from had replaced their original motor at some point.So a couple questions while I decide what to do with this unknown year/mileage motor



1) is there anything on the motor that could be used to look up info on it such as the year it was produced or linking it to a VIN?



2) compression was 210-212-200-205. Leakdown was 2%-3%-3%-3%

Leakdown seems good but the compression seems a little low? Just wondering from people who know more than I do if it seems like a healthy engine.

Originally Posted by Ashikabi (Post 3396818)

Should have a VIN on the motor somewhere right?

Sent from my ONEPLUS A5010 using Tapatalk

Originally Posted by NoHaveMSG (Post 3396821)

Here are the stampings and tag of a 13’ block I have. I don't know if this is helpful. What I would assume is the vin plate is on the passenger side towards the bottom.





Sent from my iPhone using Tapatalk

Originally Posted by NoHaveMSG (Post 3396821)

Here are the stampings and tag of a 13’ block I have. I don't know if this is helpful. What I would assume is the vin plate is on the passenger side towards the bottom.

https://uploads.tapatalk-cdn.com/202...03bda4ed27.jpg

https://uploads.tapatalk-cdn.com/202...2f062f00b2.jpg

https://uploads.tapatalk-cdn.com/202...ef083a0737.jpg




Sent from my iPhone using Tapatalk