Can anyone confirm if TWS T66-F Wheels 18x9.5 +45s clear Brembos?
 

If car has coilovers? Searched all over & could not get confirmation.

TIA

Yes it does.

Assuming you know about more wheels than already listed on this post, the community would definitely appreciate if you could share more info on that thread.

Well... I just pulled a trigger on a set--so I sure hope they'll clear lol

Seriously, per their site, they will.

I'll post up pics once mounted to verify.

You got some BADASS wheels.

With the +45 offset, depending on the tires you run and/or suspension, you may want to run spacers to not rub the tire at full lock.

Got them for the (lack of) weight.

MCS coilovers & 275s (actually A052s Yoks in 265, but they're as wide as most 275s). Will be running -3 in front & -2 rear. Should I be able to get by without rolling? Thanks.

You might rub the inner tire on the coilovers with 275s.

your issue is inboard, not outboard.

^^^ thinking abt that, too. Ran +42 Mach V 18x9.5s w/ 275 Hoosiers on my old Turbo FR-S & no issues. But... Was only running ~-2.3in front w/ that setup. -3 may be an issue. So a 3mm spacer effectively gets me back to +42.

Thanks, guys...

Confirmed: yards (or at least fingers) to spare for clearance.

Getting some rubbing, but trying to determine where. The car may be a bit too low in the front. Will try raising it slightly to see if that works. Running -3.2 degrees camber up front.

Rears have zero issues w/ -2.2

265 Yoko A052s square setup.

Very neutral setup & fantastic turn-in.

https://live.staticflickr.com/65535/...ce9b868f_b.jpg

https://live.staticflickr.com/65535/...16a1c8e0_b.jpg

https://live.staticflickr.com/65535/...d831e250_b.jpg

Thanks for the info, added to the PP Brembo thread