(SoCal) JDL v2 turbo kit
 

* UPDATED PICTURES *
*PRICE DROP*

Hey guys parting out my JDL auto turbo kit. The kit made excellent power and the BEST spooling noises IMHO. The kit was used for about 8k miles right up until I bent a rod. Everything included is as following:

ECUTEK cable and dongle
Grimmspeed EBCS
Omni 4 bar MAP sensor
GTX2867r gen2
3inch titanium down pipe
Custom cold air intake with literally like 20 miles on the new 4inch K&N filter
EL manifold
Turbosmart EWG with dump tube
Turbosmart BOV
Black Cerkote heat dissipating coated Intercooler
Oil feed and return lines
All the cold parts were just recently wrapped in heat reflective tape by DEI.
$3800OBO SoCal local pick up only!

BUMP remember it’s OBO

BUMP

No one wants boost?
BUMP

Oh no....this one does. Just not in my budget for a while yet

Haha well lmk when it is!

If it's still around...I'm guessing mid to late 2020

BUMP make me an offer!

Just curious about your bent rod.. what were the driving conditions when it bent? High load in low rpm? Boost level? Fuel?

I'm so conflicted on if I should build the motor before getting a kit.. I feel like I'd rather roll the dice and try to drive conservative boosted while saving for the motor build than build the motor and then wait to get the kit.. seems more fun :)

Sent from my Pixel XL using Tapatalk

Sorry for the late reply brother, I was always VERY careful while driving to not add load at low RPMs. My motor was boosted for about 30k miles. Both supercharged and turbo. When I bent the rod I was just doing a high boost pull on the freeway. 4th gear in an auto is VERY long so I imagine it was just too much stress. I knew it would happen eventually but I had more than enough fun with the time I had. The life of your motor is gonna depend a lot on your driving habits, tuner and quality of fuel. Other than that it’s just a matter of time.

BUMP

BUMP open to offers

BUMP price drop, 4000 local pick up

Bump