Quad Exhaust Lip?
 

So I've been doing some looking around for a quad exhaust lip to install in place of the stock one that comes with the FR-S because I have been keeping up with a company that may be releasing one that I may be interested in purchasing.

Of course I have seen the TRD version which looks very nice but the thing I am worried about is: that after looking at some photos it looks like it hangs a bit lower than the stock(Dual/all black lip) one and wont match up with the stock side skirts

I dont have any interest in adding on an entire body kit. I'm not so much interested in that as I am putting on a quad exhaust, lip spolier, and wheels.

Simple and clean for me is just fine. Does anyone know or have you seen in person how much the actual drop is in the rear and if it would be extremely noticeable? if it is, then i obviously wont go that route.

Ive also seen some companies doing quad exhaust test vidoes and noticed they have simply cut out the stock lip by hand but that doesn't look clean. Could the plastic be cut and molded for a clean lip by a company?

thanks for any input.

Bump...asking the same question

Look into the TRD bumper trim for the quad tip. Not the actually piece that goes along the whole bottom of the bumper, but rather two separate pieces that you mount to finish off the sections that would be cut. I just got my set from UPS today.

Do you have a pic of the quad exhaust lip?

http://www.trdparts.jp/86_performanc...uffler-gar.jpg

Got it from Carson Toyota. Waited a few weeks for it.